Bmw e90 ncs expert coding3/31/2024 ![]() ![]() The wires and MOST connectors for the TCU are very short and required me to cut off the black plastic loop that held them in place so I could get the TCU out far enough to disconnect it. Thankfully, BMW had the TCU/MULF bracket installed in a way that after removing the two bolts I could see the other side was just held in place with metal tabs that it slides out of when you lift it and pull it to the left. The only hiccup I have at the moment is that I can't figure out where the CAN High and Low wires are that I should be tapping into, other than that, the install was a cake walk! I have an E88 and although I ended up disassembling the entire rear seat and ski-bag passthrough only to realize the passthrough was clipped into the trunk liner in such a way that I was afraid of breaking it since I couldn't find anything specific to the e88 in this regard. Using post here: I made the harness I needed. I swapped out my TCU/MULF setup for the Single Combox TCU unit (Not the media one but the one with telemetrics since I had the TCU/MULF combo). ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |